The planetary cycloid reducer can be widely used in petroleum, environmental protection, chemical, cement, transportation, textile, pharmaceutical, food, printing, lifting, mining, metallurgy, construction, power generation and other industries as a driving or decelerating device. The machine is divided into horizontal, vertical, double-shaft and direct-coupled assembly methods.Its unique and stable structure can replace ordinary cylindrical gear reducers and worm gear reducers in many cases. Therefore, planetary cycloid reducers are widely used in various industries and fields and are generally welcomed by users.Conditions of use 1. Cycloidal pinwheel reducers are allowed to be used in continuous work situations, and they are allowed to run in both forward and reverse directions.Some models of cycloidal pinwheel reducers only allow one-way rotation. 2. The rated speed of the input shaft is 1500 rpm. When the input power is greater than 18.5 kW, it is recommended to use a 960-pole motor with 6 rpm. 3. The working positions of the horizontally installed cycloid reducer are all horizontal.The maximum horizontal inclination angle during installation is generally less than 15.When it exceeds 15, other measures should be adopted to ensure adequate lubrication and prevent oil leakage. 4. The output shaft of the cycloid reducer cannot be subjected to large axial force and radial force, and other measures must be taken when there is a large axial force and radial force.Lubrication 1. The horizontal cycloid reducer adopts oil pool lubrication under normal conditions, and the oil level can be kept in the middle of the oil window. When the working conditions are bad and the ambient temperature is high, the circulating lubrication can be used. 2. Cycloid pinwheel reducer generally chooses 40# or 50# mechanical oil lubrication at room temperature. In order to improve the performance of the reducer and extend the service life of the cycloid pinwheel reducer, it is recommended to use 70# or 90# extreme pressure gears. Oil, lubricating oil should be reconsidered when working under high and low temperature conditions. 3. The vertical installation of the planetary cycloid reducer must prevent the oil pump from cutting off the oil to avoid damage to the parts of the reducer. 4. When refueling, you can turn on the vent cap on the upper part of the seat to refuel.When draining the oil, turn the drain plug at the bottom of the main seat to drain the dirty oil.There is no lubricating oil inside the reducer when it leaves the factory. 5. The first refueling operation for 100 hours should be replaced with new oil, (and the internal dirty oil should be cleaned) and then continue to work afterwards, replaced every six months (8-hour work system), if the working conditions are bad, the oil change time can be appropriately shortened. Practice has proved that frequent cleaning and oil change of the reducer (such as 3-6 months) play an important role in prolonging the service life of the reducer.Lubricating oil should be replenished frequently during use. 6. The factory-made reducer has been greased and replaced every six months.The grease adopts aluminum disulfide-2# or 2L-2# lithium-based lubricating grease.
